Torque converter seal, replacing

WARNING: This page is about a different car, the 2010 Audi A8, 2009 Audi A8, 2008 Audi A8, 2007 Audi A8, and 2004 Audi A8. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Extractor Lever VW 681

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Extractor lever VW 681

Fig 2: Thrust Piece T10137

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Thrust piece T10137

Work procedure

Remove transmission → Transmission, removing and installing .
Attach transmission to assembly stand → Transmission, attaching to assembly stand .
Carefully remove torque converter.

Fig 3: Removing Torque Converter Seal Using Extractor Lever VW 681

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove torque converter seal using Extractor Lever VW 681.
Apply ATF to circumference and sealing lips of oil seal.

Installation position: The open side of the sealing ring faces the transmission.

Fig 4: Using Thrust Piece T10137 To Drive In Sealing Ring For Torque Converter Up To Thrust Piece Stop

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Using thrust piece T10137 , drive in sealing ring for torque converter up to thrust piece stop.