Service Interval Display (SID), resetting after service

Rapid data transfer HELP
Select function XX

Indicated on display:

Adaptation
Enter channel number XX

Indicated on display:

NOTE:

The service interval display serves to remind the driver that the vehicle is due for servicing. Messages appear in the Driver's Information Display.
The service reminder will first appear 2000 km (1200 mi) before the next service is due. The display message comes up for 5 seconds every time terminal 15 is activated, and changes in steps of 100 km (62 mi.). Example of service interval display message: "SERVICE IN 1300 KM" will appear after the vehicle has been driven 13,700 km.

NOTE:

When the service actually becomes due the message "SERVICE" will appear in the central display window for 5 seconds each time the ignition is switched on.
A service is required after an elapsed period of 12 months, even if the distance covered in this time is less than 15,000 km (10,000 mi.).
Servicing will always be required every 15000 km (10,000 mi.) in other words the Oil Change and the Inspection Service will be performed together at the end of the 15,000 km (10,000 mi.) interval.
The service interval display can also be reset without using VAG 1551 scan tool/1552. Refer to Service interval display, resetting after a service without using VAG 1551/1552 .
Software version of instrument cluster. Refer to Instrument cluster On Board Diagnostic (OBD), initiating .

Channel 2 Adaptation 1 →
< - 1 3- >

Indicated on display:: the display will indicate the service interval function:

1 - = set service interval: instrument cluster display will then show:

"SERVICE"

NOTE: The service interval display can only be reset via direct input.

Channel 2 Adaptation 1
Enter adaptation value XXXXX

Indicated on display:

The service interval is reset (adapted) by entering the following values:

Adaptation value	Set / reset service interval
00000	Reset

Enter the appropriate adaptation value (00000) via the button pad to reset the service interval.
Press button -0- five times.

Channel 2 Adaptation 1 Q
Enter adaptation value 00000

Indicated on display (example only):

Channel 2 Adaptation 0 →
< - 1 3- >

Indicated on display:

0 - means service is reset,

i.e. "SERVICE IN 15000 km" will be indicated in the instrument cluster after confirming input using the Q-button.

Channel 2 Adaptation 0 Q
Store changed value?

Indicated on display:

Channel 2 Adaptation 0 →
Changed value is stored

Indicated on display: