Floor pad front, removing and installing

NOTE: The following list refers to Fig 1.

Front left floor cover
- Removing:
  - Remove nut -5-.
  - Unclip floor cover from guide pins -3- and remove.
Front right floor cover
- Unclip and remove from guide pins -3-.
Guide pin
- 2 parts
Floor pad, rear
- Removing:
- Driver and passenger airbag removing. See FRONT SEAT, REMOVING AND INSTALLING .
  - Remove rear seat bench or remove power adjustable individual seat. See REAR SEAT BENCH, REMOVING AND INSTALLING or ELECTRICALLY ADJUSTABLE INDIVIDUAL SEATS, REMOVING AND INSTALLING .
  - Unclip both trim pieces lower C-pillar at lower area. See LOWER C-PILLAR TRIM, REMOVING AND INSTALLING .
  - Unclip entry sill inner, on both sides. See SILL MOLDING INTERIOR, REMOVING AND INSTALLING .
  - Remove B-pillar lower trim. See B-PILLAR TRIM, REMOVING AND INSTALLING .
  - Remove upper right trim A-pillar. See A-PILLAR UPPER RIGHT TRIM, REMOVING AND INSTALLING .
  - Pry out caps at floor outlet, unscrew floor outlet.
  - Remove floor cover, front-right -2-.
  - Unclip and turn back floor cover, front-left -1- out of guide pins -3-.
  - Remove center console and air flow channel for rear seat area. See CENTER CONSOLE, REMOVING AND INSTALLING .
  - Carefully loosen rear floor cover -4- from floor group and fold together in center.
  - With second installer pry out toward rear door opening.
Plastic nut

Fig 1: Identifying Floor Pad Front

Courtesy of AUDI OF AMERICA, INC.