Control module for high-intensity gas discharge lamp -J343-, left, removing and installing: Removing

Remove wheel housing liner, front left.
See FRONT WHEELHOUSING LINER, REMOVING AND INSTALLING .
Disconnect electrical harness connector from control module for high-intensity gas discharge lamp -J433- at headlight and remove cable securing mechanism (cable tie).
Remove both bolts -2- and remove control module -1- together with bracket. See Fig 1.
Remove Phillips-head screws and remove control module -1- from bracket.

Fig 1: Removing Bolts & Control Module For High-Intensity Gas Discharge Lamp, Left

Courtesy of AUDI OF AMERICA, INC.