Lock cylinder, removing and installing

Fig 1: Lock Cylinder Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Removal:

• Remove bolts - 2  - (2x) of lock trim - 3  -.
• Detach lock lever from below from catches (2x).
• Pry off top of lock lever using screwdriver.

• Installing: 

Installation is reverse of removal.

Fig 2: Lock Cylinder Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Lock lever

2 - Bolts

3 - Latch trim

4 - Latch trim

• When rear backrest is locked, pin - 1  - is 2 mm above lock trim.
• If rear backrest is not locked, pin lies approx. 20 mm above lock trim and a red mark is visible.

5 - Lock cylinder

• To remove and install the lock cylinder, ignition key must be inserted.