Separating cover and upholstery from seat pan

1 - Cover and upholstery

• Removal:

• Remove seat: Vehicles until 10.04 → Front power seats with memory, removing and installing , vehicles from 11.04 → Front power seats with memory, removing and installing .
• Remove side trim on sill side → Side panels on door sill side, removing and installing .
• Remove side trim on tunnel side → Tunnel-side side trim, removing and installing .
• Remove the backrest → Front backrest, removing and installing .

• Remove bolts - 3  - (2x).
• Remove bracket - 2  -.
• Disconnect connector for seat heater - 7  -.
• Remove clip - 4  -.

• Pry out grip channels - 5  - all around.
• Disengage tab - 6  -.
• Remove cover and upholstery - 1  -.

• Installing: 

Installation is reverse of removal.

• For vehicles with LATCH "Lower Anchor and Tethers for Children" bracket and new cover - 1  -, cover must be cut in at LATCH "Lower Anchor and Tethers for Children" bracket.

2 - Support

3 - Screws, (2x)

4 - Clip

5 - Peripheral fastening strips

6 - Tab

7 - Seat heating connector