LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2002 >> S4 Quattro, Standard >> Repair and Diagnosis >> Restraints >> Passive Restraints >> Body Interior - Except Cabriolet (72-Seat-Frames & 74-Seats-Upholstery, Covers) >> 72 - Seat - Frames >> Front Recaro seats, vehicles from 11.04 >> Storage compartment, removing and installing

Storage compartment, removing and installing

Special tools, testers and auxiliary items required 

Fig 1: Special Tool - Engine And Transmission Holder VAS 6095
GW00004543Courtesy of VOLKSWAGEN UNITED STATES, INC.
Fig 2: Fixture For Seat Repair VAS 6136
GW00011774Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing 

CAUTION:
  • Observe safety precautions for work on airbags → Airbag safety precautions .
  • Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "electrostatically discharge". This can be done by touching door striker, for example.
Fig 3: Storage Compartment Remove/Install Components
GW00020927Courtesy of VOLKSWAGEN UNITED STATES, INC.
NOTE:
  • For illustrative purposes, the storage compartment is shown closed in the illustration.

Installing 

Installation is reverse of removal. Observe the following when doing so:

CAUTION:
  • Observe safety precautions for work on airbags → Airbag safety precautions .
  • Before handling airbag units (e.g. disconnecting electrical connector), the person handling it must "electrostatically discharge". This can be done by touching door striker, for example.
NOTE:
  • Ensure that electrical connections are pushed in as far as stop and engage with a click.
CAUTION: Ignition must be on when connecting battery. If pyrotechnic components (e.g. airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.

Tightening torques  → Passenger side storage compartment, from 06.06, assembly overview