Airbag Control Module J234 , removing and installing

CAUTION: Always read updated safety regulations concerning replacement of safety components following an accident → Safety components following an accident, replacing 

• Disconnect battery Ground (GND) strap.
• Remove footwell vent and trim → Footwell vent and footwell vent trim, removing and installing .

Fig 1: Airbag Control Module And Nuts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove nuts - 2  - (3x).
• Tightening torque 6 Nm
• Take out control module - 1  -.

Fig 2: Removing Airbag Control Module

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Press catch - 3  -.
• Flick over retainer - 4  - at connector - 2  - in direction of arrow.
• Pull connector - 2  - out of control module - 1  -.
• Remove control module.

NOTE:

• Reenter coding if control module is replaced.

• Switch ignition on.

CAUTION: Make sure there is no-one in the vehicle when connecting battery.

• Close doors.
• Connect battery Ground (GND) strap.

NOTE:

• After connecting the battery, check vehicle equipment (radio, clock, electric windows) → 91 RADIO, TELEPHONE, NAVIGATION, TRIP COMPUTER or Owners Manual.
• If the Airbag Malfunction Indicator Lamp (MIL) K75 signals a malfunction after assembling, then DTC memory must be erased and checked again using vehicle diagnostic, testing and information system VAS 5051 A scan tool.