Adapting Service Reminder Indicator (SRI), inspection service interval (distance in km)
This function is used to adapt the distance remaining (in kilometers) before the next inspection service is due.
Indicated on display
- Press buttons -1- and -0- to select "Adaptation" function 10.
- Press -Q- button to confirm input.
Indicated on display
- Press buttons -0- and -6- to insert channel number 06.
- Press -Q- button to confirm input.
Indicated on display
The display will show the number of kilometers remaining before the next inspection service is due. In this example, "5" = 5000 km.
NOTE:
- Values can only be input in increments of 1000 km. Therefore, the distance is indicated in units of 1000 km.
- Even in countries where the speedometers are calibrated in miles, adaptation must be done in metric units. Convert the required distance interval from miles to kilometers to get the required adaptation value.
- Conversion of miles to kilometers: miles x 1.609 = km.
- Kilometers are displayed in "Read Measuring Value Block" function 08, display groups 002 and 050.
- Notes regarding replacement of the instrument cluster. See REPLACEMENT OF INSTRUMENT CLUSTER, INPUT VALUES .
- Only direct input of the values is possible using the VAG1551 scan tool.
- If an incorrect value is input "Adaptation" function 10 is ended and must be initiated again.
- Press --> button.
Indicated on display
- Input required value using keypad on VAG1551 scan tool, filling in initial spaces with "0."
Example:
Specification: 30000 km
- Input "00030" using keypad.
Indicated on display
- Press -Q- button to confirm input.
Indicated on display
- Press -Q- button to confirm input.
Indicated on display
- Press -Q- button to confirm input.
Indicated on display
- Press --> button to complete adaptation.