Diagnostic Trouble Code (DTC) memory, checking (scan tool function 02)

Switch on printer with PRINT button (indicator light in button lights up).
Indicated on display.

Fig 1: Scan Tool Display - DTC Memory Checking (1 Of 5)
Courtesy of AUDI OF AMERICA, INC.
Press buttons 0 and 2 to select function "Check DTC memory."
Indicated on display.

Fig 2: Scan Tool Display - DTC Memory Checking (2 Of 5)
Courtesy of AUDI OF AMERICA, INC.
Press Q button to confirm input.
The number of stored malfunctions appears on the display.

Fig 3: Scan Tool Display - DTC Memory Checking (3 Of 5)
Courtesy of AUDI OF AMERICA, INC.
The number of stored DTCs or "No DTC recognized" appears in the display and are printed one after the other.
With printed list of DTCs go to fault table for instructions on how to correct malfunctions. See DIAGNOSTIC TROUBLE CODE (DTC) TABLE .
If "No DTC recognized" is displayed, the program will return to the initial position after pressing the button.

Fig 4: Scan Tool Display - DTC Memory Checking (4 Of 5)
Courtesy of AUDI OF AMERICA, INC.

Indicated on display.

Fig 5: Scan Tool Display - DTC Memory Checking (5 Of 5)
Courtesy of AUDI OF AMERICA, INC.

If display is different: See scan tool operating instructions.
End output (function 06). See END OUTPUT (SCAN TOOL FUNCTION 06) .
Switch off ignition and disconnect Data Link Connector (DLC).