Adaptation (function 10): Notes
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
Individual functions are called up by entering the appropriate adaptation channel numbers (See adaptation table. See Adaptation Table ).
NOTE:
- Using measuring value blocks 010, 011, 012 and 015, the values that need to be transferred to the new instrument cluster can be read out before replacement.
- Adaptation channels 42, 43, 44 and 45 (Measuring value blocks 013 see Measuring value block 013 , 014 see Measuring value block 014 and 015 see Measuring value block 015 ) must be adapted when the instrument cluster is replaced.
- Adaptation channels 60, 61, and 62 are only needed when the instrument cluster communicates with the corresponding BUS system.
- Measuring value blocks 125 and 126. See Measuring value block 125 and Measuring value block 126 . Indicate the participants in the powertrain CAN-bus.
- Measuring value block 130. See Measuring value block 130 . Indicates the participants in the comfort system CAN-bus.
- Measuring value block 140. See Measuring value block 140 . Indicates the participants in the information CAN-bus.