Initiating "Adaptation" function 10: Notes

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Initiate output Diagnostic Test Mode of instrument cluster. See INSTRUMENT CLUSTER ON BOARD DIAGNOSTIC (OBD), INITIATING .

Display on VAS 5051:

Fig 1: VAS 5051 Tester Display - Adaptation (Instrument Cluster) (1 Of 3)

Courtesy of AUDI OF AMERICA, INC.

In selection -1-, select the diagnostic function "10 - Adaptation".

Display on VAS 5051:

Fig 2: VAS 5051 Tester Display - Adaptation (Instrument Cluster) (2 Of 3)

Courtesy of AUDI OF AMERICA, INC.

Enter channel number Max. input value = 99

Enter desired adaptation channel in button field -2-. See Adaptation Table .
Press -Q- button to confirm input.

NOTE: After changing an adaptation value or ending an adaptation channel, "10 - Adaptation" function must be selected again before selecting another adaptation channel!

Display on VAS 5051:

Fig 3: VAS 5051 Tester Display - Adaptation (Instrument Cluster) (3 Of 3)

Courtesy of AUDI OF AMERICA, INC.

1 - Channel X read and test
2 - Text display of selected channel or No indication
5 - The sliding bar is positioned on the current adaptation value