Initiating "Read Measuring Value Block": Notes
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
Display on VAS 5051:
- Press selection -1- of vehicle system "01 -Engine electronics".
- Wait until the next indication appears on display.
Display on VAS 5051:
- Control module identification of Engine Control Module (ECM).
- Control module identification of immobilizer
- Click on --> button
Display on VAS 5051:
- Select diagnostic function "08 - read measured value block" in selection -1-.
Display on VAS 5051:
- Enter display group Max. input value = 255
- Select function "066" in button field -2- for "Display group number 066" and press Q button to confirm input.
Display on VAS 5051:
- Display group 66
-
- Display field 1
- Display field 2
- Display field 3
- Display field 4
NOTE:
If no display follows, a display field is not assigned.
NOTE:
For vehicles with automatic transmission, the voltage supply for the cruise control switch is not switched on until a speed of above 30 km/h is reached with selector lever in position -2-, -3- or -D-. The voltage supply will then be maintained at idle, as long as a driving mode (aside from -1- or -R-) is selected.
- Road test vehicle and exceed 30 km at least once. Do not switch off engine upon completion. Leave selector lever in -2-, -3- or -D-.
- Engage parking brake.