Basic Setting (function 04): Notes
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
Basic setting must be performed after replacing a headlight, axle sensor or the control module. Observe the following:
- Vehicle must be in a precisely defined load condition.
NOTE:
Current specified values and procedures for load condition can be found in the Repair Manual "Maintenance".
See MAINTENANCE .
- Rock vehicle (move bumpers up and down several times. allowing vehicle to come to a rest on its own).