Instrument cluster, removing and installing: Installing
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2005 Audi allroad, 2004 Audi allroad, 2004 Audi A6, 2003 Audi allroad, and 2003 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
Installation is reverse of removal, noting the following:
- Connect electrical harness connectors and affix wiring harness to rear of instrument cluster with cable ties.
- After installation, perform a function test of the instrument cluster.
- If the function test is OK, enter the input values for the instrument cluster (i.e.: SRI etc. where applicable):
- Code instrument cluster according to market and equipment versions using the VAS 5051 tester
- Adapt odometer reading to new/exchange instrument cluster using the VAS 5051 tester
- Adapt anti-theft immobilizer functions supported by the instrument cluster to Engine Control Module (ECM) using the VAS 5051 tester