Maximum time interval

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 Audi S8, 2003 Audi A8, 2002 Audi S8, 2002 Audi A8, and 2001 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

This function is used to set a fixed maximum time in days in the instrument cluster for the SRI.

Indicated on display

Fig 1: V.A.G 1551 Scan Tool Display - Maximum Time Interval (1 Of 9)

Courtesy of AUDI OF AMERICA, INC.

Press -1- and -0- and confirm by pressing the -Q- button.

Indicated on display

Fig 2: V.A.G 1551 Scan Tool Display - Maximum Time Interval (2 Of 9)

Courtesy of AUDI OF AMERICA, INC.

Press -Q- button to confirm input.

Indicated on display:

Fig 3: V.A.G 1551 Scan Tool Display - Maximum Time Interval (3 Of 9)

Courtesy of AUDI OF AMERICA, INC.

Press buttons 4- and -4-.
Press -Q- button to confirm input.

Indicated on display (example only): Factory adjusted value for the time in days until next service is indicated (here for example 365 represents 365 days).

Fig 4: V.A.G 1551 Scan Tool Display - Maximum Time Interval (4 Of 9)

Courtesy of AUDI OF AMERICA, INC.

NOTE:

The currently valid specifications can be found in the "Maintenance" book.
Input of current specified value is only possible in units of one day, indication in display also changes in units of one day.
When replacing instrument cluster, this value is already adjusted.
It is only possible to input values via direct input using the keypad of the scan tool.
If incorrect value is input, the "Adaptation" function is terminated and must be re-initiated.