Output Diagnostic Test Mode (function 03): Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 Audi S8, 2003 Audi A8, 2002 Audi S8, 2002 Audi A8, and 2001 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Only perform output Diagnostic Test Mode when vehicle is stationary and engine is not running!
- Switch on ignition
- Switch on low beams.
- If malfunctions are found during output Diagnostic Test Mode, determine cause of malfunction and replace faulty component if necessary.
The following system conditions can be activated during actuator test:
- Headlights are lowered
- Headlights are raised
- Warning lamp is activated