Basic Setting (function 04): Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 Audi S8, 2003 Audi A8, 2002 Audi S8, 2002 Audi A8, and 2001 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

Basic setting must be performed after replacing a headlight, axle sensor or the control module. Observe the following:

Vehicle must be in a precisely defined load condition.

NOTE: Current specified values and procedures for load condition can be found in the Repair Manual "Maintenance."

See HEADLIGHT AIM, ADJUSTING .

Rock vehicle (move bumpers up and down several times, allowing vehicle to come to a rest on its own).