Check DTC Memory (function 02)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 Audi S8, 2003 Audi A8, 2002 Audi S8, 2002 Audi A8, and 2001 Audi S8. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The displayed DTC information is updated only when initiating OBD or with "Erase DTC Memory" function 05.

Switch printer on via the PRINT button (indicator lamp in button lights up).

Indicated on display

Fig 1: V.A.G 1551 Scan Tool Display - Check DTC Memory - Function 02 (1 Of 5)

G02729399

Courtesy of AUDI OF AMERICA, INC.

Press buttons -0- and -2-. This selects "Check DTC memory", function 02.

Indicated on display

Fig 2: V.A.G 1551 Scan Tool Display - Check DTC Memory - Function 02 (2 Of 5)

G02729400

Courtesy of AUDI OF AMERICA, INC.

Press -Q- button to confirm input.

The number of stored malfunctions appears in the display.

Fig 3: V.A.G 1551 Scan Tool Display - Check DTC Memory - Function 02 (3 Of 5)

G02729401

Courtesy of AUDI OF AMERICA, INC.

The stored malfunctions are displayed and printed out one after the other.

Check print-out against DTC table and repair all malfunctions as necessary. See DIAGNOSTIC TROUBLE CODE (DTC) TABLE .

If "No DTC recognized" is displayed, the program will return to "Select function XX" after the --> button is pressed.

Fig 4: V.A.G 1551 Scan Tool Display - Check DTC Memory - Function 02 (4 Of 5)

G02729402

Courtesy of AUDI OF AMERICA, INC.

Indicated on display

Fig 5: V.A.G 1551 Scan Tool Display - Check DTC Memory - Function 02 (5 Of 5)

G02729403

Courtesy of AUDI OF AMERICA, INC.

If something else is displayed:

See Operating instructions of Scan Tool (ST)

End Output (function 06). See END OUTPUT (FUNCTION 06) .
Switch off ignition and disconnect diagnostic connector.