LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2014 >> TSX Special Edition, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 88 (Manual Transmission (4-CYL)) >> Reverse Lockout Solenoid Test

Reverse Lockout Solenoid Test

WARNING: This page is about a different variant/trim than selected.
  1. Remove the reverse lockout solenoid (see REVERSE LOCKOUT SOLENOID DISASSEMBLY/REASSEMBLY ).
  2. Connect jumper wires from the battery positive terminal to reverse lockout solenoid 2P connector terminal No. 2, and from the battery negative terminal to reverse lockout solenoid 2P connector terminal No. 1.
    Fig 1: Identifying Reverse Lockout Solenoid 2P Connector
    G07768131Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Make sure the reverse lockout solenoid works. If the reverse lockout solenoid does not work, replace it.
    NOTE: The inhibitor should be pushed out when applying battery voltage to the solenoid, and the inhibitor should be released when there is no battery voltage at the solenoid.
scientia non olet · About LEMON Manuals