Glove Box Lock Cylinder Replacement

NOTE: Take care not to scratch the glove box.

Remove the glove box (see GLOVE BOX SEPARATOR REMOVAL/INSTALLATION ).
While lifting the glove box handle (A), pull out one end of the retainer (B) with a hook-shaped tool of its slot.
NOTE: Do not remove the retainer entirely. Leave one end of the retainer in its original position when removing the lock cylinder.

Fig 1: Pulling Out End Of Retainer
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the glove box lock cylinder (A).

Fig 2: Identifying Glove Box Lock Cylinder
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Reinstall the end of the retainer (A) in its slot, then install the lock cylinder (B). Push the cylinder into place securely until the retainer snaps into place.

Fig 3: Installing End Of Retainer
Courtesy of AMERICAN HONDA MOTOR CO., INC.