LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2014 >> TSX Special Edition, Automatic Trans >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Exterior Lights (4-CYL) >> License Plate Light Replacement

License Plate Light Replacement

  1. Open the trunk lid or the tailgate.
  2. Remove the rear license plate trim panel (see REAR LICENSE TRIM REPLACEMENT - SEDAN ).
  3. Pull the license plate light assembly out, and disconnect the 2P connector (A) from the light.

    License Plate Light: 5 W 

    Fig 1: Identifying 2P Connector (A), Lens (B) And Housing (C)
    G07770519Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Separate the lens (B) and housing (C), then remove the bulb (D).
  5. Install the license plate light in the reverse order of removal.
scientia non olet · About LEMON Manuals