Rear License Trim Replacement - Sedan

Special Tools Required

KTC Trim Tool Set SOJATP2014*

*Available through the Acura Tool and Equipment Program; call 888-424-6857

NOTE:

Take care not to scratch the trunk lid.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Pull out the rear license trim (A) to detach the clips (B, C), then remove the trim.

Fig 1: Identifying Rear License Trim And Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the trim in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.