Bearing Outer Race Replacement

Special Tools Required 

• Driver Handle, 15 x 135L 07749-0010000
• Bearing Driver Attachment, 78 x 80 mm 07NAD-PX40100

1. Remove the oil seals from the transmission housing and the clutch housing (see OIL SEAL REPLACEMENT  ).
2. Remove the bearing outer race, the spacer, and the 81 mm shim from the transmission housing by heating the housing to about 212 CF (100 °C) with a heat gun.
   NOTE: Do not reuse the 81 mm shim if the outer race was driven out.
   Fig 1: Removing Bearing Outer Race, Spacer And Shim From Transmission Housing By Heating Housing Using Heat Gun

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Remove the bearing outer race and the spacer from the clutch housing by heating the housing to about 212 °F (100 °C) with a heat gun.
   Fig 2: Removing Bearing Outer Race And Spacer From Clutch Housing By Heating Housing Using Heat Gun

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Install the 81 mm shim (A), the spacer (B), and the bearing outer race (C) into the transmission housing (D) using the 15 x 135L driver handle (E) and the 78 x 80 mm bearing driver attachment (F).
   Fig 3: Installing Shim, Spacer And Bearing Outer Race Into Transmission Housing Using Driver Handle And Bearing Driver Attachment

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Install the spacer (A) and the bearing outer race (B) into the clutch housing (C) using the 15 x 135L driver handle (D) and the 78 x 80 mm bearing driver attachment (E).
   Fig 4: Installing Spacer And Bearing Outer Race Into Clutch Housing Using Driver Handle And Bearing Driver Attachment

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. Install the oil seals into the transmission housing and the clutch housing (see OIL SEAL REPLACEMENT  ).