LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2014 >> MDX SH-AWD >> Repair and Diagnosis >> Electrical >> Motors, Switches, Relays >> Electrical System - Testing & Troubleshooting / Gen Info (Except Hybrid) >> Symptom Troubleshooting >> Battery Symptom Troubleshooting - Low or Dead Battery (2016 2017 2018 2019 2020)

Battery Symptom Troubleshooting - Low or Dead Battery (2016 2017 2018 2019 2020)

Low or Dead Battery 

NOTE: 

Indication Example 

- Latest History -
Duration: 22 hours
Discharge: 300 mAh
Average current: 14mA
Data Value
Current immediately after IG OFF -3. 82 A
Average current from immediately after IG OFF to 1 hour -990 mA
Average current from 1 hour to 2 hours -10 mA
Average current of 1 hour just before IG ON -10 mA
  1. PGM-FI system check

    - 1. Check for PGM-FI DTCs.

    DTC Description Confirmed DTC Pending DTC
    P0562 CHARGING SYSTEM LOW VOLTAGE    
    DTC Description Confirmed DTC Pending DTC
    P065A ACG NO CHARGING MALFUNCTION    
    P16BB ALTERNATOR B TERMINAL CIRCUIT LOW VOLTAGE    
    P16E7 BATTERY BLOWER LIN COMMUNICATION ERROR    

    Are DTCs P0562, P065A, P16BB, and/or P16E7 indicated?

    YES 

    Go to indicated DTCs troubleshooting - Refer to: Fuel and Emissions Systems DTC Troubleshooting Index (KA/KC models) (2016) or Fuel and Emissions Systems DTC Troubleshooting Index (2017 2018) or Fuel and Emissions Systems DTC Troubleshooting Index (2019 2020). .

    NO 

    Go to step 2.

  2. Battery fan motor check

    - 1. Test the battery fan motor.

    Is the battery fan motor OK?

    YES 

    Go to step 3.

    NO 

    Replace the battery fan motor .

  3. Parasitic draw check

    - 1. Check all the BATTERY CONSUMPTION CURRENT HISTORY with the HDS.

    Battery Consumption Current History

    Battery size Threshold of the average current
    L3 -10 mA

    Are all the values of average current from 1 hour to 2 hours less than the threshold?

    YES 

    Check the 12 volt battery.

    NO 

    Go to step 4.

  4. Problem verification

    - 1. Turn the vehicle to the OFF (LOCK) mode.

    - 2. Get out of the vehicle, and close all doors and trunk securely.

    - 3. Lock the doors with the keyless remote.

    - 4. Make sure the individual map lights are turned off and the security alarm system is armed.

    - 5. Wait 130 minutes or more.

    - 6. Turn the vehicle to the ON mode.

    - 7. Check the latest BATTERY CONSUMPTION CURRENT HISTORY with the HDS.

    Battery Consumption Current History

    Battery size Threshold of the average current
    L3 -10 mA

    Is the value of average current from 1 hour to 2 hours less than the threshold?

    1. YES 

      Intermittent failure, the system is OK at this time. The possible cause could be that an incorrect parasitic draw value was recorded:

      • A switch was not turned off.
      • The vehicle's accessories were operated for a long time with the vehicle ignition was in the ACCESSORY mode.

      NO 

      Go to the parasitic draw check - Refer to: Parasitic Draw Check (2016 2017 2018 2019 2020) .