Memorizing Rear Suspension Full Rebound Position

Do the rear suspension full rebound position memorizing whenever you do any of these actions:

• Replace the active damper control unit.
• Replace the rear damper unit.
• Remove and install the rear suspension stroke sensor.
• In the specific DTC troubleshooting.

1. With the ignition switch in LOCK (0), connect the HDS to the data link connector (DLC) (A) under the driver's side of the dashboard.
   Fig 1: Identifying Data Link Connector

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Turn the ignition switch to ON (II).
3. Make sure the HDS communicates with the vehicle and the active damper control unit. If it does not, go to the DLC circuit troubleshooting (see DLC CIRCUIT TROUBLESHOOTING ).
4. Check for DTCs and make sure no DTC is indicated.
   NOTE: For specific operations, refer to the Help menu that came with the HDS.
5. Turn the ignition switch to LOCK (0).
6. Raise and support the vehicle (see LIFT AND SUPPORT POINTS ).
   NOTE: Verify the rear tires are suspended off the ground.
7. Make sure the rear suspension stroke sensors are installed correctly, and the linkages are properly connected (see SUSPENSION STROKE SENSOR REPLACEMENT ).
8. Turn the ignition switch to ON (II).
9. Follow the screen prompts on the HDS to do the DAMPER STROKE CALIBRATION.
   NOTE: For specific operations, refer to the Help menu that came with the HDS.
10. Turn the ignition switch to LOCK (0).