Suspension Stroke Sensor Replacement

NOTE:

Removal and replacement of the right side suspension stroke sensor is the same procedure as for the left side suspension stroke sensor.
After installing the rear suspension stroke sensor, do the memorizing rear suspension full rebound position (see MEMORIZING REAR SUSPENSION FULL REBOUND POSITION ).

Raise the vehicle, making sure it is securely supported.
Disconnect the 3P connector (A) from the suspension stroke sensor (B).

Fig 1: Identifying 3P Connector And Suspension Stroke Sensor (Left-Front)
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 2: Identifying 3P Connector And Suspension Stroke Sensor (Left-Rear)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the bolt and nut, then remove the suspension stroke sensor.
Install the sensor in the reverse order of removal.
After installing, do the headlight initial position learning procedure