LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2009 >> MDX V6-3.7L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Cylinder Head Assembly >> Valve Cover >> Service and Repair >> Cylinder Head Cover Removal

Cylinder Head Cover Removal




Cylinder Head Cover Removal

1. Remove the intake manifold. Intake Manifold Removal and Installation

2. Remove the six ignition coils. Service and Repair

3. Remove the dipstick.

4. Remove the two bolts (A) securing the harness holder, and disconnect the front air fuel ratio (A/F) sensor connector (B), front secondary heated oxygen sensor (secondary HO2S) connector (C), exhaust gas recirculation (EGR) valve connector (D) and engine coolant temperature (ECT) sensor 1 connector (E).

5. Disconnect the three injector connectors from the injectors on the rear side cylinder head.






6. Remove the power steering hose bracket mounting bolt (A), the harness holder mounting bolts (B), and the engine ground cable bolt (C).

7. Remove the engine ground cable (D) and disconnect the breather hose (E).






8. Remove the cylinder head covers.

FRONT:





REAR:





scientia non olet · About LEMON Manuals