2-6

Active Damper System DTC Troubleshooting: 2-5, 2-6

DTC 2-5: Right-front/Right-rear Suspension Stroke Sensor Range/Performance Problem

DTC 2-6: Left-front/Left-rear Suspension Stroke Sensor Range/Performance Problem

1. Turn the ignition switch to LOCK (0).

2. Remove the appropriate suspension stroke sensor. Suspension Stroke Sensor Replacement (With Active Damper System) Do not disconnect the sensor connector.
NOTE: After troubleshooting for the left side suspension stroke sensor, do the headlight initial position learning procedure. Programming and Relearning





3. Start the engine, and wait 5 seconds.

4. Check the SUS STROKE_S VOLTAGE (RF), (LF), (RR), or (LR) in the ACTIVE DAMPER SYSTEM DATA LIST with the HDS while moving the suspension stroke sensor arm through a complete stroke. Compare the voltage/rotation angle between the chart and the measurements.
NOTE: The voltage should increase (decrease) within 90 degrees of the sensor arm rotation from the first voltage change point.

Is the voltage as specified?
YES - Replace the active damper control unit. Service and Repair

NO - Replace the appropriate suspension stroke sensor. Suspension Stroke Sensor Replacement (With Active Damper System)