Suspension Stroke Sensor Replacement (With Active Damper System)

Suspension Stroke Sensor Replacement

NOTE:

- Right side of suspension stroke sensor for active damper system is the same procedure as left side suspension stroke sensor.

- After installing the rear suspension stroke sensor, do the memorizing rear suspension full rebound position. Programming and Relearning

1. Raise the vehicle, make sure it is securely supported.

2. Disconnect the 3P connector (A) from the suspension stroke sensor (B).

3. Remove the bolt and nut, then remove the suspension stroke sensor.

4. Install the sensor in the reverse order of removal.

5. After installing, do the headlight initial position learning procedure. Programming and Relearning

LEFT-FRONT





LEFT-REAR