Starter Removal and Installation: Removal

Make sure you have the anti-theft codes for the audio system and navigation system. Make sure the ignition switch is OFF.
Remove the battery trim (see step 2 under UPPER FENDER TRIM REPLACEMENT ).
Disconnect the negative cable from the battery.
Remove the engine cover.

Fig 1: Identifying Engine Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the vacuum hose (A) and transmission dipstick (B).

Fig 2: Removing Vacuum Hose And Transmission Dipstick
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the harness clamp (A).

Fig 3: Identifying Starter Mounting And Wiring
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Disconnect the starter cable (B) from the B terminal, then disconnect the BLK/WHT wire (C) from the S terminal.
Remove the two bolts holding the starter, then remove the starter.