Upper Fender Trim Replacement

Special Tools Required

KTC trim tool set SOJATP2014 *

* Available through the American Honda Tool and Equipment Program; call 888-424-6857

NOTE:

Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
Take care not to scratch the grille and body.

Disconnect the washer reservoir tubes (A). Detach the clips and release the pin (B), then remove the right upper fender trim (C).

Fig 1: Identifying Right Upper Fender Trim, Washer Reservoir Tubes And Pin
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Release the hooks (A, B), then remove the battery trim (C) from the upper fender trim (D) and grille cover (E).

Fig 2: Identifying Battery Trim, Upper Fender Trim And Grille Cover
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Detach the clips, and release the pin (A), then remove the left upper fender trim (B).

Fig 3: Identifying Left Upper Fender Trim And Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the upper fender trim in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips into place securely.
- Make sure the windshield washer tubes are connected properly.