LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Cylinder Head >> Rocker Arm Assembly Removal

Rocker Arm Assembly Removal

  1. Remove the cam chain (see CAM CHAIN REMOVAL  ).
  2. Loosen the rocker arm adjusting screws (A).
    Fig 1: Identifying Rocker Arm Adjusting Screws
    G05490124Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the camshaft holder bolts. To prevent damaging the camshafts, loosen the bolts in sequence two turns at a time, in the sequence shown.
    NOTE: Bolt (1) is not on all engines.
    Fig 2: Identifying Camshaft Holder Bolts In Sequence
    G05490125Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the cam chain guide B, camshaft holders, and camshafts.
  5. Insert the bolts (A) into the rocker shaft holder, then remove the rocker arm assembly (B).
    Fig 3: Identifying Rocker Arm Assembly Bolts
    G05490126Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals