LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Lubrication >> Engine Oil Replacement >> '06-08 models

'06-08 models

  1. Warm up the engine.
  2. Remove the maintenance lid (A).
    Fig 1: Maintenance Lid And Drain Bolt W/Torque Specifications
    G05490248Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the drain bolt (B), and drain the engine oil.
  4. Reinstall the drain bolt with a new washer (C).
  5. Refill with the recommended oil (see LUBRICANTS AND FLUIDS ).

    Capacity 

    At Oil Change: 4.0 L (4.2 US qt) 

    At Oil Change including Filter: 4.2 L (4.4 US qt) 

    After Engine Overhaul: 5.3 L (5.6 US qt) 

  6. Connect the Honda Diagnostic System (HDS) to the data link connector (DLC) (see step 2 ofHOW TO USE THE HDS (HONDA DIAGNOSTIC SYSTEM) ).
  7. Turn the ignition switch ON (II).
  8. Make sure the HDS communicates with the vehicle and the engine control module (ECM)/powertrain control module (PCM). If it doesn't communicate, troubleshoot the DLC circuit (see DLC CIRCUIT TROUBLESHOOTING ).
  9. Select BODY ELECTICAL with the HDS.
  10. Select ADJUSTMENT in the GAUGES MENU with the HDS.
  11. Select RESET in the MAINTENANCE MINDER with the HDS.
  12. Select RESETTING THE ENGINE OIL LIFE with the HDS.
    NOTE: If you changed the ATF at the same time with the engine oil, select RESETTING THE ENGINE OIL LIFE AND ATF with the HDS instead.
  13. Run the engine for more than 3 minutes, then check for oil leakage.
  14. Reset the maintenance display (see RESETTING THE MAINTENANCE INFORMATION DISPLAY ).
scientia non olet · About LEMON Manuals