LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis >> Maintenance >> Schedule >> Maintenance >> Maintenance Minder >> General Information >> Resetting the Maintenance Information Display

Resetting the Maintenance Information Display

NOTE:
  • The vehicle must be stopped to reset the display.
  • If a required service is done and the display is not reset, or if the maintenance display is reset without doing the service the system will not show the proper maintenance timing. This can lead to serious mechanical problems because there will be no accurate record of when the required maintenance is needed.
  • The engine oil life and maintenance item(s) can be reset independently only with the HDS.
  1. Turn the ignition switch to the ON (II) position.
  2. If system message(s) are displayed, press the INFO knob to cancel the display.
  3. Push and release the SELECT/RESET knob repeatedly until the engine oil life indicator is displayed.
  4. Press and hold the SELECT/RESET knob for about 10 seconds, the, "SETUP" mode display appears.
    NOTE:
    • If you are resetting the display when the engine oil life is more than 15%, make sure any maintenance item(s) requiring service are done before resetting the display.
    • To cancel the "SETUP" mode, press the INFO knob repeatedly until the "CANCEL" indicator is displayed, then press the SELECT/RESET knob.
      Fig 1: Identifying Oil Life RESET Display
      G05489891Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Press the INFO knob to select "RESET," then press the SELECT/RESET knob. The maintenance item code(s) will disappear, and the engine oil life will reset to "100".
    Fig 2: Identifying Oil Life At 100 Percent Displayed
    G05489892Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals