A-Pillar Trim

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

NOTE:

Put on gloves to protect your hands.
Take care not to bend or scratch the trim and panels.
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.

Remove the A-pillar trim (A).
1. Pull out the door opening trim (B) as needed.
2. Pry the A-pillar cap (C) out until it is stopped by the hooks (D) in the grommet (E).
3. Pull the trim back by hand to detach the clip, then pull the trim up.
4. Release the hooks on the grommet and pull the cap out. Discard the cap.
  
  Fig 1: Pulling Out Door Opening Trim
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the trim in the reverse order of removal, and note these items:
- Check if the clip is damaged or stress-whitened, and if necessary, replace it with a new one.
- Do not reuse the A-pillar cap; always replace it.
- If the side curtain airbag has deployed, replace the A-pillar trim with a new one.
- To prevent the side curtain airbags from deploying improperly and possibly causing injury, inspect removed pieces and replace them if they have any of these types of damage:
  - Any cracks, deformations, or stress-whitened areas in the A-pillar trim (A)
  - Any cracks, or stress-whitened areas in the grommet and clip seating surfaces (B)
  - Bent or broken grommet (C)
- Replace any damaged parts with new ones.
- Make sure the top of the trim overlaps with the headliner correctly (see CHECKING AND ADJUSTING THE HEADLINER/PILLAR TRIM OVERLAP ).
- Push the clip into place securely.
  
  Fig 2: Identifying Pillar Trim And Grommet
  Courtesy of AMERICAN HONDA MOTOR CO., INC.

Special Tools Required

KTC trim tool set SOJATP2014 *

* Available through the American Honda Tool and Equipment Program; call 888-424-6857