Glove Box Removal/Installation

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

1. Detach the hook (A) of the glove box damper (B), and remove the glove box stop (C) on each side.
   Fig 1: Identifying Glove Box Stop

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Disconnect the trunk lid opener main switch connector (A) and detach the harness clip (B).
   Fig 2: Identifying Trunk Lid Opener Main Switch Connector

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. While holding the glove box (A), remove the screws, then remove the glove box.
   Fig 3: Identifying Glove Box Screws

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. From the inside of the dash, gently push out on the front of the dashboard side cover (A) to release the hooks (B), to remove the cover.
   Fig 4: Identifying Dashboard Side Cover Hooks

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Remove the screw, then remove the glove box damper (A).
   Fig 5: Identifying Glove Box Damper Screw

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. Install the glove box in the reverse order of removal.