LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> SRS (Supplemental Restraint System) >> SRS Unit Replacement >> Removal

SRS Unit Replacement: Removal

NOTE: If you are disconnecting only SRS unit connector A, skip step  2.
  1. Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
  2. Disconnect both seat belt tensioner connectors (see DISCONNECTING SYSTEM CONNECTORS ).
  3. Remove the center console (see CENTER CONSOLE REMOVAL/INSTALLATION ).
  4. Remove the rear vent ducts (see step 4 on DASHBOARD/STEERING HANGER BEAM REMOVAL/INSTALLATION ).
  5. Disconnect SRS unit connector A (28P), SRS unit connector B (28P), SRS unit connector C (16P), and remove the TORX bolts (D), then pull out the SRS unit.
    Fig 1: Identifying SRS Unit Connectors And Torx Bolts
    G05489830Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals