Center Console Removal/Installation

Special Tools Required 

KTC trim tool set SOJATP2014 *

* Available through the American Honda Tool and Equipment Program; call 888-424-6857

1. M/T model: Loosen the locknut (A) to remove the shift knob (B).
   Fig 1: Identifying Shift Knob

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Starting towards the front of the vehicle detach the clips by pulling the center console panel (A) up. If equipped, disconnect the seat heater switch connectors (B).
   Fig 2: Identifying Seat Heater Switch Connectors

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Remove the center upper pocket (A).
   1. Open the lid, then pull on the lower edge of the pocket to detach the clips. Do not pull on the lid while removing the center upper pocket. When the pocket is loose, close the lid and remove it.
   2. Disconnect the pocket light bulb socket (B) and detach the harness clip (C).
      Fig 3: Identifying Pocket Light Bulb Socket

      Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Remove the screws, disconnect the front accessory power socket connector (A) and detach the harness clip (B), then remove the center lower pocket (C).
   Fig 4: Identifying Center Lower Pocket

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Open the console box lid (A), then remove the console mat (B) and screws (C, D).
   Fig 5: Identifying Console Mat And Screws

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. Remove the center console (A).
   1. Disconnect the rear accessory power socket connector (B), auxiliary jack assembly unit connector (C), and detach the clip (D).
   2. Pull up the rear portion of the console to release the hooks (E), then remove the console.
      Fig 6: Identifying Rear Accessory Power Socket Connector And Auxiliary Jack Assembly Unit Connector

      Courtesy of AMERICAN HONDA MOTOR CO., INC.
7. Install the console in the reverse order of removal, and check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.