LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> SRS (Supplemental Restraint System) >> Front Impact Sensor Replacement >> Removal

Front Impact Sensor Replacement: Removal

  1. Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
  2. Disconnect the driver's airbag 4P connector (see DISCONNECTING SYSTEM CONNECTORS ), the front passenger's airbag 4P connector (see DISCONNECTING SYSTEM CONNECTORS ), and both seat belt tensioner 4P connectors (see DISCONNECTING SYSTEM CONNECTORS ).
  3. Remove the front inner fender ('04-05 models) (see FRONT INNER FENDER REPLACEMENT ) or the splash shield ('06-08 models) (see SPLASH SHIELD REPLACEMENT ).
  4. Disconnect the engine compartment wire harness 2P connector (A), and using a TORX T30 bit remove the two TORX bolts (B), then remove the front impact sensor (C).

    '04-05 models 

    Fig 1: Identifying Engine Compartment Wire Harness 2P Connector And Torx Bolts (04-05 Models)
    G05489838Courtesy of AMERICAN HONDA MOTOR CO., INC.

    '06-08 models 

    Fig 2: Identifying Engine Compartment Wire Harness 2P Connector And Torx Bolts (06-08 Models)
    G05489839Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals