Valve, Spring, and Valve Seal Removal

Special Tools Required 

Valve spring compressor attachment 07757-PJ1010A

Identify the valves and valve springs as they are removed so that each item can be reinstalled in its original position.

1. Remove the cylinder head (see CYLINDER HEAD REMOVAL  ).
2. Using an appropriate-sized socket (A) and plastic mallet (B), lightly tap the valve spring retainer to loosen the valve cotters.
   Fig 1: Taping Valve Retainer

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install the valve spring compressor attachment and valve spring compressor. Compress the valve spring, and remove the valve cotters.
   Fig 2: Removing Valve Cotters

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Remove the valve spring compressor, valve spring compressor attachment, valve spring retainer, and valve spring.
5. Install the valve guide seal remover.
   Fig 3: Identifying Valve Guide Seal Remover

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
6. Remove the valve seal.
   Fig 4: Removing Valve Seal

   Courtesy of AMERICAN HONDA MOTOR CO., INC.