Removal

3UR-FE INTAKE / EXHAUST: EXHAUST MANIFOLD: REMOVAL

1. REMOVE ENGINE ROOM SIDE COVER LH Removal

2. REMOVE ENGINE ROOM SIDE COVER RH Removal

3. REMOVE UPPER RADIATOR SUPPORT SEAL Removal

4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH Removal

5. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH Removal

6. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

(a) Remove the 10 bolts and No. 1 engine under cover.
7. REMOVE NO. 2 ENGINE UNDER COVER

(a) Remove the 2 bolts and No. 2 engine under cover.
8. REMOVE FRONT FENDER APRON SEAL FRONT RH

(a) Using a clip remover, remove the 3 clips and fender apron seal.
9. REMOVE FRONT FENDER APRON SEAL REAR RH

(a) Using a clip remover, remove the 4 clips and fender apron seal.
10. REMOVE FRONT FENDER APRON SEAL FRONT LH

(a) Using a clip remover, remove the 4 clips and fender apron seal.
11. REMOVE FRONT FENDER APRON SEAL REAR LH

(a) Using a clip remover, remove the 4 clips and fender apron seal.
12. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE

(a) Remove the dipstick.
(b) Remove the bolt and dipstick guide.
(c) Remove the O-ring from the dipstick guide.
13. REMOVE TAILPIPE ASSEMBLY Removal

14. REMOVE CENTER EXHAUST PIPE ASSEMBLY Removal

15. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY Removal

16. REMOVE FRONT EXHAUST PIPE ASSEMBLY Removal

17. REMOVE PROPELLER SHAFT HEAT INSULATOR

(a) Remove the 2 bolts and heat insulator.
18. REMOVE NO. 2 MANIFOLD STAY

(a) Remove the 2 bolts and manifold stay.
19. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

(a) Remove the 3 bolts and heat insulator.
20. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH

(a) Remove the 10 nuts, exhaust manifold and 2 gaskets.
21. REMOVE NO. 1 MANIFOLD STAY

(a) Remove the 2 bolts and manifold stay.
22. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

(a) Remove the 3 bolts and heat insulator.
23. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH

(a) Remove the 2 nuts and insulator from the exhaust manifold.

(b) Remove the 10 nuts, exhaust manifold and 2 gaskets.