Headlamp: Service and Repair

Headlamp Assembly

Aerodynamic










Sealed Beam









Removal and Installation

NOTE: Make sure that the headlamp switch and the ignition switch are in the OFF position.

Aerodynamic

1. Remove the 3 bolts and the headlamp assembly.
- Disconnect the electrical connectors.


Sealed beam

2. Remove the side lamp/front turn signal lamp. For additional information, refer to Side Lamp/Front Turn Signal Lamp Bulb Side Lamp/Front Turn Signal Lamp Bulb.

3. Remove the 4 screws and the headlamp retaining ring.

4. Remove the headlamp assembly.
- Disconnect the electrical connector.


All headlamp types

5. To install, reverse the removal procedure.