Safety Belt Buckle, Rear [2018-2022 | 2021, B4204T18; B4204T47 | 2021, E400V6]: Removal

NOTE:

Removal steps in this procedure may contain installation details.

Courtesy of VOLVO CARS CORPORATION

NOTE:

Note the correct location of the seat belt, which is shown in the graphic.

Set the vehicle to Inactive mode, described in user mode. Refer to: USAGE MODE

Remove the seat cushion, rear seat. Refer to: SEAT CUSHION, REAR SEAT

APPLIES TO THE RIGHT-HAND SIDE

Courtesy of VOLVO CARS CORPORATION

Disconnect the connector.

Remove the cable harness clips.

Courtesy of VOLVO CARS CORPORATION

Torque: Buckle safety belt to body, 48Nm

Remove the nut.

Fold marked part aside.

Courtesy of VOLVO CARS CORPORATION

Remove the marked part.

APPLIES TO THE LEFT-HAND SIDE:

Courtesy of VOLVO CARS CORPORATION

Disconnect the connectors.

Remove the cable harness clips.

Courtesy of VOLVO CARS CORPORATION

Torque: Buckle safety belt to body, 48Nm

Remove the nut.

Remove the marked part.

NOTE:

The following steps are only necessary when installing a new component.

Courtesy of VOLVO CARS CORPORATION

Remove the clips.

The part is not to be reused.

Courtesy of VOLVO CARS CORPORATION

Torque: Buckle safety belt to body, 48Nm

Install the marked component.

Install the nut.

Courtesy of VOLVO CARS CORPORATION

Connect the connectors.

Courtesy of VOLVO CARS CORPORATION

Use new clips.

Install the clip(s).