Removal & Installation

REMOVAL

NOTE:

Removal steps in this procedure may contain installation details.

Battery, disconnection. Refer to: BATTERY DISCONNECTING AND CONNECTING

Remove bushing push rod. Refer to: BUSHING PUSH ROD

Remove the wiper mechanism, windscreen. Refer to: WIPER MECHANISM, WINDSHIELD

Courtesy of VOLVO CARS CORPORATION

Remove the marked part.

Torque: Strut and spring assembly bar to spring strut turret, 30 Nm
Torque: M6, 10 Nm

ALTERNATIVE 1

Courtesy of VOLVO CARS CORPORATION

Disconnect the connector.

Remove the screw.

Fold marked part aside.

Torque: M8, 24 Nm

ALTERNATIVE 2

Courtesy of VOLVO CARS CORPORATION

Disconnect the connector.

Remove the screw.

Fold marked parts aside.

Torque: M8, 24 Nm

ALL VEHICLES

Courtesy of VOLVO CARS CORPORATION

CAUTION:

Pull carefully.

Loosen the nuts.

Fold marked parts aside.

Torque: Ø6 mm diameter brake line, 14 Nm

Courtesy of VOLVO CARS CORPORATION

Disconnect the connector.

Fold marked part aside.

Courtesy of VOLVO CARS CORPORATION

Remove the nuts.

Torque: Master cylinder, to Brake booster, 27 Nm

Courtesy of VOLVO CARS CORPORATION

Remove the marked part.

Remove the part carefully

TRANSFERRING COMPONENTS

Courtesy of VOLVO CARS CORPORATION

Remove the marked part.

INSTALLATION

To install, reverse the removal procedure.

Perform Battery, connecting. Refer to: BATTERY DISCONNECTING AND CONNECTING

Perform bleeding air brake system. Refer to: BRAKE SYSTEM BLEEDING

Calibration according to: Diagnostics / Components / Control modules/ Central Electronic Module (CEM) / Diagnostic sequences / Calibration of brake pedal sensor and brake pedal angle sensor

NOTE:

The following steps are only necessary when installing a new component.

Order and download software according to: VIDA/Software/Hardware Changes