Removal & Installation

REMOVAL 

Perform High voltage battery disconnection. Refer to: HIGH VOLTAGE BATTERY, DISCONNECTING AND CONNECTING

Remove bushing push rod. Refer to: BUSHING PUSH ROD  

Remove the wiper mechanism, windscreen. Refer to: WIPER MECHANISM, WINDSHIELD

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Remove the marked part.

Torque:  M8, 24 Nm

Courtesy of VOLVO CARS CORPORATION

Loosen the hose clamp.

Remove the hose.

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Disconnect the connectors.

Torque:  M6, 10 Nm

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

1. Torque:  M6, 10 Nm
2. Torque:  M5, 5 Nm

Courtesy of VOLVO CARS CORPORATION

Remove the screw.

Torque:  M6, 10 Nm

Courtesy of VOLVO CARS CORPORATION

Remove the screw.

Fold marked part aside.

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Torque:  IGM, to Body frame, 13 Nm

Courtesy of VOLVO CARS CORPORATION

Lift the marked component forward.

Courtesy of VOLVO CARS CORPORATION

Undo the hose from the connection.

Courtesy of VOLVO CARS CORPORATION

Disconnect the connectors.

Loosen the clip.

Courtesy of VOLVO CARS CORPORATION

Remove the nuts.

Torque:  Master cylinder, to Brake booster, 27 Nm

Courtesy of VOLVO CARS CORPORATION

Fold marked part aside.

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Remove the marked part.

HINT: It may be necessary to twist or turn the component. 

Torque:  M8, 24 Nm

TRANSFERRING COMPONENTS 

Courtesy of VOLVO CARS CORPORATION

INSTALLATION 

To install, reverse the removal procedure.

Courtesy of VOLVO CARS CORPORATION

Use:  Thread locker normal, 1161053

Connect High Voltage Battery. Refer to: HIGH VOLTAGE BATTERY, DISCONNECTING AND CONNECTING

Calibration according to: Diagnostics / Components / Control modules/ Central Electronic Module (CEM) / Diagnostic sequences / Calibration of brake pedal sensor and brake pedal angle sensor