Inflatable Curtain [2018-2022]: Removal
Removal steps in this procedure may contain installation details.
Follow instructions about safety information pyrotechnical system. Refer to: SAFETY INFORMATION PYROTECHNICAL SYSTEMS
See information regarding the handling of non-deployed pyrotechnical parts. Refer to: HANDLING NON-DEPLOYED PYROTECHNICAL PART
Remove the following items:
- A-pillar trim panel. Refer to: A-PILLAR TRIM PANEL
- C-pillar trim panel. Refer to: C-PILLAR TRIM PANEL
- inner rear view mirror. Refer to: INNER REAR VIEW MIRROR
The graphic shows the back of the component before removal.
Loosen the marked detail.
On both sides.
Fold marked part aside.
On both sides.
Torque: Entry handle, to bracket, 6Nm
Remove the screws.
On both sides.
The graphic shows the back of the component before removal.
Remove the marked detail/details.
On both sides.
Torque: M6, 10Nm
Remove the screw.
Remove the cable harness clips.
Remove the cable harness clips.
ON BOTH SIDES.
Release the lock.
Remove the marked part.
The graphic shows the back of the component before removal.
Remove the marked part.
Remove the screws.
Fold marked part aside.
Fold marked part aside.
Loosen the screws.
VEHICLES WITH ROOF OPENING PANEL
Disconnect the connector.
Take extra care not to crease the headliner.
Velcro strip
Use: Interior trim remover
VEHICLES WITHOUT ROOF OPENING PANEL
Take extra care not to crease the headliner.
Velcro strip
Use: Interior trim remover
ALL VEHICLES
Lower to suitable height.
Perform battery disconnecting and connecting. Refer to: BATTERY DISCONNECTING AND CONNECTING
The supplemental restraint system (SRS) is active for a certain length of time after the power supply has been disconnected. Wait for a minimum of 30 seconds before disconnecting or removing any SRS components.
Torque: Entry handle bracket, to Body, 7Nm
Remove the screws.
Remove the marked part.
Dismantle the connector ignition cable. Refer to: IGNITER WIRE CONNECTOR
Disconnect the connector.
Remove the screw.
Release the catches.
Remove the screws.
Remove the screws.
Remove the marked part.
Remove the marked part.