Bushing Push Rod [2022, B420T]: Installation
To install, reverse the removal procedure.
NOTE:
A click confirms that the component is in the correct position.
Make sure that the component is fitted in exactly the same position as the old one.
WARNING:
Ensure that the push rod ends in the correct position by pulling the brake pedal at the pedal pad with a traction force of max 100 N.
CAUTION:
Make sure that the component is positioned correctly.
A click confirms that the component is in the correct position.
Calibration according to: Diagnostics / Components / Control modules/ Central Electronic Module (CEM) / Diagnostic sequences / Calibration of brake pedal sensor and brake pedal angle sensor