Inflatable Curtain [2019-2022]: Removal

NOTE:

Removal steps in this procedure may contain installation details.

Follow instructions about safety information pyrotechnical system. Refer to: [SAFETY INFORMATION PYROTECHNICAL SYSTEMS]

See information regarding the handling of non-deployed pyrotechnical parts. Refer to: [HANDLING NON-DEPLOYED PYROTECHNICAL PART]

Remove the following items:

A-pillar trim panel. Refer to: [A-PILLAR TRIM PANEL]
inner rear view mirror. Refer to: [INNER REAR VIEW MIRROR]

Courtesy of VOLVO CARS CORPORATION

NOTE:

The graphic shows the back of the component before removal.

Courtesy of VOLVO CARS CORPORATION

On both sides.

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

NOTE:

The graphic shows the back of the component before removal.

Courtesy of VOLVO CARS CORPORATION

On both sides.

Loosen the marked detail.

Courtesy of VOLVO CARS CORPORATION

On both sides.

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

On both sides.

Torque: Panel, to C pillar, 4.5Nm

Remove the screw.

Courtesy of VOLVO CARS CORPORATION

NOTE:

The graphic shows the back of the component before removal.

Courtesy of VOLVO CARS CORPORATION

Courtesy of VOLVO CARS CORPORATION

On both sides.

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

Fold marked part aside.

Courtesy of VOLVO CARS CORPORATION

Torque: Entry handle, to bracket, 6Nm

Remove the screws.

Courtesy of VOLVO CARS CORPORATION

Remove the fastener.

Courtesy of VOLVO CARS CORPORATION

Disconnect the connectors.

Courtesy of VOLVO CARS CORPORATION

Remove the screws.

Courtesy of VOLVO CARS CORPORATION

On both sides.

Remove the fastener.

Courtesy of VOLVO CARS CORPORATION

On both sides.

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

NOTE:

The graphic shows the back of the component before removal.

Courtesy of VOLVO CARS CORPORATION

On both sides.

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

On both sides.

Remove the screws.

Courtesy of VOLVO CARS CORPORATION

On both sides.

Remove the cable harness clips.

VEHICLES WITH HEATED WINDSHIELD

Courtesy of VOLVO CARS CORPORATION

Torque: M6, 10Nm

Remove the screw.

Courtesy of VOLVO CARS CORPORATION

Disconnect the connector.

Courtesy of VOLVO CARS CORPORATION

Courtesy of VOLVO CARS CORPORATION

Perform battery disconnecting and connecting. Refer to: [BATTERY DISCONNECTING AND CONNECTING]

WARNING:

The supplemental restraint system (SRS) is active for a certain length of time after the power supply has been disconnected. Wait for a minimum of 30 seconds before disconnecting or removing any SRS components.

Courtesy of VOLVO CARS CORPORATION

CAUTION:

Take extra care not to crease the headliner.

NOTE:

Velcro strip

Use: Interior trim remover

Courtesy of VOLVO CARS CORPORATION

CAUTION:

Take extra care not to crease the headliner.

HINT: This step may require the aid of another technician.

Remove the part carefully

Courtesy of VOLVO CARS CORPORATION

Torque: Entry handle bracket, to Body, 8Nm

Remove the nuts.

Remove the marked part.

Disconnect connector ignition cable. Refer to: [IGNITER WIRE CONNECTOR]

Courtesy of VOLVO CARS CORPORATION

Disconnect the connector.

Courtesy of VOLVO CARS CORPORATION

NOTE:

Make sure at the installation that the component has not become twisted.

Torque: Inflatable curtain to the body, 7Nm

Loosen the screws.

Courtesy of VOLVO CARS CORPORATION

NOTE:

Make sure at the installation that the component has not become twisted.

Torque: Inflatable curtain to the body, 7Nm

Loosen the screws.

Courtesy of VOLVO CARS CORPORATION

NOTE:

Make sure at the installation that the component has not become twisted.

Torque: Inflatable curtain to the body, 7Nm

Loosen the screws.

Courtesy of VOLVO CARS CORPORATION

Remove the marked part.

Courtesy of VOLVO CARS CORPORATION

Remove the marked part.