Brake Booster [2021-2022, E400V6]: Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the following items:
- Bushing push rod. Refer to: BUSHING PUSH ROD
- battery. Refer to: BATTERY
Fold the cable aside.
Remove the marked part.
Remove the cable harness clips.
Fold the cable aside.
Remove the screws.
Remove the marked part.
- Torque: M8, 24Nm
- Torque: Battery box, to Body, 13Nm
Remove the cable harness clips.
Disconnect the connector.
Fold the cable harness aside.
Disconnect the connector.
Fold the cable harness aside.
CAUTION:
Pull carefully.
Loosen the nuts.
Fold marked parts aside.
Torque: Ø8 mm diameter brake line, 16Nm
Remove the nuts.
Torque: M8, 24Nm
Remove the marked part.
Remove the part carefully